1064nm±1nm

Side-pumped semiconductor (diode) pumping

Internal-Synchronization Illumination / External-Synchronization Illumination
(Trigger Delay: 304.0 μs ± 0.1 μs)

≤150×102×55mm

≤850g

Electro-optic Q-switch (EO Q-switch)

15ns ±5ns

≤0.15mrad

≤8%(RMS)

Short-duration irradiation mode: The irradiation time for each cycle is 17 seconds, followed by a 30-second interval. The system can perform up to 8 consecutive irradiation cycles.

Long-duration irradiation mode: The irradiation time for each cycle is 60 seconds, followed by a 45-second interval. The system can perform up to 4 consecutive irradiation cycles.

≤0.5mrad

· Minimum Measuring Distance: ≤ 300 m

· Maximum Measuring Distance: ≥ 15 km
(under conditions of a 2.3 m × 2.3 m target, diffuse reflectivity ≥ 0.2, visibility ≥ 20 km, and relative humidity ≤ 70%)

· Ranging Frequency: 1–20 Hz (up to 3 simultaneous targets)

· Ranging Accuracy: ≤ 5 m

· Probability of Valid Ranging: ≥ 98%

· Continuous Ranging Operating Time: 90 s
(20 Hz continuous operation for 90 s, rest time ≤ 5 minutes before continuing ranging)

RS422

+5 V differential line driver/receiver, RS-422 interface (delay from external synchronization signal to laser emission: 304.0 μs ± 0.1 μs).

l Precise Frequency Coding

l Time Coding

l Pseudo-Random Coding

<+-1us

DC 20V ~ 28V

During operation, the average power consumption is not more than 55W, and the peak power consumption is not more than 100W.

Operating temperature: −40 °C
Storage temperature: −45 °C

Operating temperature: +60 °C
Storage temperature: +65 °C

Relative humidity: 95% ± 3%
Temperature: +35 °C ± 2 °C
Storage duration: 72 h

The equipment shall withstand flight vibration and the shocks occurring during takeoff and landing, and all components shall meet the environmental conditions of vehicle transportation.

The vibration profile is a swept-frequency spectrum:

l From 5 Hz to 16 Hz, constant-displacement sinusoidal vibration with an amplitude of 1.5 mm;

l From 16 Hz to 60 Hz, constant-acceleration sinusoidal vibration with an acceleration level of 1.5 g.

Each of the three axes shall be vibrated for 36 minutes.

Test condition:
The product shall be mounted on the vibration table in its normal operating configuration and powered on during the test.

Post-test requirement:
After vibration testing, the equipment shall operate normally.