JET RULER is very pleased to announce the production of what is one of aviations most epic aircraft ever, the General Dynamics F16 Fighting Falcon.

This 1/6 scale version has been designed with an improved wing area, to provide better performance and flight characteristics.

SPECIFICATIONS:

Model: 1/6 F16

Wingspan: 1640mm

Length: 2470mm – Plus pitot tube

Weight: 17kg

BASIC SETUP:

Control throws:

Aileron: 25 degrees up / 25 degrees down – 40% Expo

Measured from the wingtip

Rudder: 30 degrees left / 30 degrees right – 30% Expo

Elevator: 25 degrees / 25 degrees – 40% Expo

Measured from the front of the leading edge of the elevator.

The CG is 230mm from the front leading edge on the root of the wing (Factory Settings)

FEATURES:

Full composite construction, lightweight and strong

Painted outside the mold so no seam lines

Easily detachable ventral fins, helps in place with just two screws

INCLUDED HARDWARE:

Complete air frame (including fibreglass control horns)

Carbon fibre wing-tubes

Servo extension leads

Fixed Dual wall thrust pipe (for 160-240N turbines)

Fuel tank (5300ml)

Pre-prepared pushrods with ball links

Pre-glued control horns

JP electric retract gear with brake

OPTIONAL EXTRAS:

Simulate fighter cockpit

Light system

PNP and installation service

REQUIRED HARDWARE:

Turbine: 160-240N

Servos: x9

x4 middle size servo, 12-20kg)

x5 standard size servo, 30-40kg

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.

ARF plus wired version

(Linkages pre-installed PNP your own servos)

4.3L fuel tank,UAT, fuel tank exhaust port, servo extension leads, hardware, tail nozzle, Electric retracts with controller, Brake controller, pre-installed lights with controller plus extra free scale cockpit, scale jet pilot, missiles, wing bags, and maintenance stand.